For organisations

Applied RF and Microwave Engineering

Work a link budget end to end, read a transceiver as a block diagram and say what each stage costs you, weigh what spreading and coding do for a link against what they take from it, and take the measurement that shows whether any of it is true.

Time
About 52 hours
Size
21 modules ready, 5 to build with you

What the course covers

  1. 1 lessonAbout 10 minutes

    A short tour of how a lesson works. Try each kind of screen, find help, wire a first system in the Radio Lab, and learn how to tell us about a problem.

    • How a Lesson WorksMove through the screens of a lesson, answer a question and a prediction, find help, wire a first system and try the feedback button.

  2. 4 lessonsAbout 45 minutes

    Radio signals pass through every room, and none of your senses detects them. This module explains what a signal is, how a receiver separates signals, and how to read a display that shows them.

  3. 10 lessonsAbout 2 hours

    What a wave is, what the number on a radio dial measures, and what radio is made of. Then how fast radio travels, what that lets a receiver measure, and how one signal looks in time and in frequency.

  4. 14 lessonsAbout 2 hours

    Why a signal weakens with distance, and what metal, walls, hills, the curve of the Earth and noise do to it. Then how the air and the ionosphere carry radio further, what echoes and several signals tell a receiver, and why a reflection can mislead it.

  5. 10 lessonsAbout 2 hours

    Why a steady wave carries no message, and how AM, FM, single sideband and on-off keying put one on it. Then how much bandwidth a message needs, what too much modulation does, and why stations on one channel take turns.

  6. 18 lessonsAbout 3 hours

    What an antenna does and why its size follows the frequency. What happens inside a transmitter and a receiver, and how to check the cable and the match between them.

  7. 22 lessonsAbout 4 hours

    Decibels, volts and amps, and how radio users share the spectrum. How to stay safe with the mains, with batteries and near antennas.

  8. 7 lessonsAbout 2 hours

    SI prefixes and formulas, amplitude, frequency and phase with numbers, interference, field strength and polarisation, and what a sharp edge puts into the spectrum.

  9. 7 lessonsAbout 2 hours

    How AM, SSB and FM put a message on a carrier and what each costs in bandwidth, how digital keying packs bits into symbols, and what a signal's timing tells you.

  10. 14 lessonsAbout 3 hours

    Ground wave, sky wave and space wave, what the ionosphere does to each, why a signal fades, and what a moving transmitter does to its own frequency.

  11. 15 lessonsAbout 3 hours

    How each antenna works, what a radiation pattern tells you, why you need to aim a narrow beam, and how much power a mismatched feedline wastes.

  12. 15 lessonsAbout 3 hours

    Mixing down to an intermediate frequency, what limits sensitivity, and what each transmitter stage does.

  13. 12 lessonsAbout 2 hours

    Spreading a signal, hopping it around, and spending extra bits to make a link survive harsh conditions.

  14. 17 lessonsAbout 3 hours

    Where interference comes from and why your own transmitters trouble your own receivers. Which instrument shows you each type of fault.

  15. 17 lessonsAbout 4 hours

    Components that stop behaving as themselves at radio frequency, what resonance selects, and how a filter picks one signal out of many.

  16. 9 lessonsAbout 2 hours

    What an instrument shows and how it changes the circuit, setting up a spectrum analyser, how good a frequency reading is, and finding a fault in order.

  17. 12 lessonsAbout 3 hours

    Sampling and aliasing, I/Q pairs, what a transform can and cannot show, and how long a clock stays right.

  18. 13 lessonsAbout 3 hours

    Choosing an intermediate frequency, reading IP3 and compression, and what a mode asks of the stage that amplifies it.

  19. 23 lessonsAbout 4 hours

    Reactance and impedance, resonance and Q, the filter types, and power supplies.

  20. 13 lessonsAbout 2 hours

    Where a cable gets its impedance, what comes back off a mismatch, how much a station radiates, and what the ground underneath is doing to all of it.

Built with your organisation

  1. Beginner Mathematics

    Complex numbers in polar form, and why an impedance has an angle — the four hours that make the Advanced trunk readable.

  1. Software-Defined Radio: First Signals

    A receiver on the desk: tuning it and setting it so a weak signal survives beside a strong one. Telling a real signal from one your own radio creates.

  1. Software-Defined Radio: Sampling and Shape

    How much spectrum to look at and what it costs, why a copy of a signal appears far from where it was sent, and reading a signal off its trace.

  1. Applied Fundamentals

    Four systems everyone depends on: radar replies, navigation signals that you can trust, distress beacons, and satellite timing.

  1. Wireless Networks and IoT

    WiFi, Bluetooth, Zigbee, LoRa and cellular: what each one trades, and the triangle every one of them lives inside.

Teaches the radio behind the work, so your people can take part in the technical conversation.

Your organisation gives its own training and qualifications. This course does not replace them.

An RF engineering qualification and Engineers Australia Stage 1 competence both need design work and supervised practice, and both of those happen at your employer. This course is separate from both.