For organisations

RF in the Control Room

Understand where your operation depends on a radio signal, what an alarm looks like when the cause is interference rather than a fault, and what to write down before you escalate it.

Time
About 14 hours
Size
7 modules ready, 4 to build with you

What the course covers

  1. 1 lessonAbout 10 minutes

    A short tour of how a lesson works. Try each kind of screen, find help, wire a first system in the Radio Lab, and learn how to tell us about a problem.

    • How a Lesson WorksMove through the screens of a lesson, answer a question and a prediction, find help, wire a first system and try the feedback button.

  2. 4 lessonsAbout 45 minutes

    Radio signals pass through every room, and none of your senses detects them. This module explains what a signal is, how a receiver separates signals, and how to read a display that shows them.

  3. 10 lessonsAbout 2 hours

    What a wave is, what the number on a radio dial measures, and what radio is made of. Then how fast radio travels, what that lets a receiver measure, and how one signal looks in time and in frequency.

  4. 14 lessonsAbout 2 hours

    Why a signal weakens with distance, and what metal, walls, hills, the curve of the Earth and noise do to it. Then how the air and the ionosphere carry radio further, what echoes and several signals tell a receiver, and why a reflection can mislead it.

  5. 10 lessonsAbout 2 hours

    Why a steady wave carries no message, and how AM, FM, single sideband and on-off keying put one on it. Then how much bandwidth a message needs, what too much modulation does, and why stations on one channel take turns.

  6. 18 lessonsAbout 3 hours

    What an antenna does and why its size follows the frequency. What happens inside a transmitter and a receiver, and how to check the cable and the match between them.

  7. 22 lessonsAbout 4 hours

    Decibels, volts and amps, and how radio users share the spectrum. How to stay safe with the mains, with batteries and near antennas.

Built with your organisation

  1. Working With Signals Somebody Else Built

    What your operation runs on that somebody else owns, how a system shows you its output has gone bad, and how to report a fault to the person who can fix it.

  1. Where Your Operation Depends on a Signal

    Walking your own process to find the radio inside it, telling deliberate interference from a broken box, and knowing which failures arrive quietly.

  1. RF Safety: the Mechanism

    The three things a transmitter can harm — a person, something that fires electrically, and fuel — and why they are one piece of physics.

  1. Australian RF Safety Rules

    Who sets the exposure limit and what an assessment does. How to find the authority that sets the distance for your own site.

Teaches the radio behind the work, so your people can take part in the technical conversation.

Your organisation gives its own training and qualifications. This course does not replace them.

A control-room operator authorisation and an assessment against your critical infrastructure obligations each come from elsewhere; this course is separate from both. It teaches the radio your systems run on, and your site’s procedures stay your site’s.