RF for Defence Acquisition
Understand what every number in an RF specification is measured against, which of them trade against each other, and how to tell a claim that is merely optimistic from a pair of claims that contradict each other.
- Time
- About 36 hours
- Size
- 16 modules ready, 4 to build with you
What the course covers
1 lessonAbout 10 minutes
A short tour of how a lesson works. Try each kind of screen, find help, wire a first system in the Radio Lab, and learn how to tell us about a problem.
- How a Lesson WorksMove through the screens of a lesson, answer a question and a prediction, find help, wire a first system and try the feedback button.
4 lessonsAbout 45 minutes
Radio signals pass through every room, and none of your senses detects them. This module explains what a signal is, how a receiver separates signals, and how to read a display that shows them.
10 lessonsAbout 2 hours
What a wave is, what the number on a radio dial measures, and what radio is made of. Then how fast radio travels, what that lets a receiver measure, and how one signal looks in time and in frequency.
14 lessonsAbout 2 hours
Why a signal weakens with distance, and what metal, walls, hills, the curve of the Earth and noise do to it. Then how the air and the ionosphere carry radio further, what echoes and several signals tell a receiver, and why a reflection can mislead it.
10 lessonsAbout 2 hours
Why a steady wave carries no message, and how AM, FM, single sideband and on-off keying put one on it. Then how much bandwidth a message needs, what too much modulation does, and why stations on one channel take turns.
18 lessonsAbout 3 hours
What an antenna does and why its size follows the frequency. What happens inside a transmitter and a receiver, and how to check the cable and the match between them.
22 lessonsAbout 4 hours
Decibels, volts and amps, and how radio users share the spectrum. How to stay safe with the mains, with batteries and near antennas.
7 lessonsAbout 2 hours
SI prefixes and formulas, amplitude, frequency and phase with numbers, interference, field strength and polarisation, and what a sharp edge puts into the spectrum.
7 lessonsAbout 2 hours
How AM, SSB and FM put a message on a carrier and what each costs in bandwidth, how digital keying packs bits into symbols, and what a signal's timing tells you.
14 lessonsAbout 3 hours
Ground wave, sky wave and space wave, what the ionosphere does to each, why a signal fades, and what a moving transmitter does to its own frequency.
15 lessonsAbout 3 hours
How each antenna works, what a radiation pattern tells you, why you need to aim a narrow beam, and how much power a mismatched feedline wastes.
15 lessonsAbout 3 hours
Mixing down to an intermediate frequency, what limits sensitivity, and what each transmitter stage does.
12 lessonsAbout 2 hours
Spreading a signal, hopping it around, and spending extra bits to make a link survive harsh conditions.
17 lessonsAbout 3 hours
Where interference comes from and why your own transmitters trouble your own receivers. Which instrument shows you each type of fault.
11 lessonsAbout 3 hours
Convert powers to dBm, calculate the noise in a receiver, and add up a link budget to find out if a link will work.
9 lessonsAbout 2 hours
What an instrument shows and how it changes the circuit, setting up a spectrum analyser, how good a frequency reading is, and finding a fault in order.
Built with your organisation
Applied Fundamentals
Four systems everyone depends on: radar replies, navigation signals that you can trust, distress beacons, and satellite timing.
Radar Fundamentals
Pulse and FMCW radar. The range equation, radar cross section, clutter, and phased arrays.
Positioning, Navigation and Timing
Pseudoranges and trilateration, where the errors come from, how jamming and spoofing work, and what stops when the time stops arriving.
Reading an RF Specification
What each datasheet figure measures and what conditions it assumes. Which specifications trade against each other and when an optimistic claim contradicts another.
Teaches the radio behind the work, so your people can take part in the technical conversation.
Your organisation gives its own training and qualifications. This course does not replace them.
It helps you read what a contractor has written. The technical authority on it stays with the engineers, and accepting a deliverable, signing a technical assessment or holding a delegation each rest on a qualification that comes from elsewhere.