RF Specialist
Ask the right questions, and lead a conversation about RF. Covers link budgets and measurement, digital radio, filters, antenna and feedline calculations, and propagation prediction.
- Time
- About 20 hours
- Size
- 7 modules, 93 lessons
- You need
- RF Practitioner, or the same knowledge
- Maths
- Complex numbers and decibels
Before you start
This course uses the ideas from RF Practitioner.
What the course covers
Each module goes deeper into a topic from RF Practitioner.
Pro11 lessonsAbout 3 hours
Convert powers to dBm, calculate the noise in a receiver, and add up a link budget to find out if a link will work.
Builds onHow Radio Waves TravelandInside the Radio
- Watts and dBm for Any PowerConvert any power between watts and dBm, and add the gains and losses along a chain to find the level at its far end.
- Thermal Noise: Power and VoltageCalculate the thermal noise power in a bandwidth from kTB, explain why a wider channel collects more, and calculate the noise voltage across a resistor.
- Signal-to-Noise Ratio and BandwidthCalculate a signal-to-noise ratio in dB, predict what a narrower filter does to it, and find the weakest signal a mode can use.
- The Noise That Each Stage AddsConvert between noise figure and noise temperature, calculate a chain’s noise temperature, and place a lossy cable before or after the LNA.
- Noise From Outside the Receiver, and G/TIdentify atmospheric, galactic, man-made and ground noise, decide whether band or receiver noise limits a receiver, and calculate G/T.
- Energy per Bit and Channel CapacityConvert between C/N and Eb/N0, identify which one a modem’s threshold uses, calculate channel capacity, and decide if a link lacks bandwidth or signal.
- Path Loss in Any Units, and the EchoCalculate path loss in any units, and how much more an echo path loses than a one-way link and how much further that link reaches.
- The Link BudgetCalculate a link budget line by line from transmitter power to received signal level, and work back to the minimum transmitter power.
And 3 more lessons, to Two Signals in One ChannelPro9 lessonsAbout 2 hours
What an instrument shows and how it changes the circuit, setting up a spectrum analyser, how good a frequency reading is, and finding a fault in order.
Builds onInside the RadioandWhen Things Go Wrong
Pro12 lessonsAbout 3 hours
Sampling and aliasing, I/Q pairs, what a transform can and cannot show, and how long a clock stays right.
Builds onInside the RadioandBeing Heard in a Noisy World
Pro13 lessonsAbout 3 hours
Choosing an intermediate frequency, reading IP3 and compression, and what a mode asks of the stage that amplifies it.
Builds onInside the RadioandWhen Things Go Wrong
Pro23 lessonsAbout 4 hours
Reactance and impedance, resonance and Q, the filter types, and power supplies.
Builds onWhen Things Go WrongandThe Parts It Is Made Of
Pro13 lessonsAbout 2 hours
Where a cable gets its impedance, what comes back off a mismatch, how much a station radiates, and what the ground underneath is doing to all of it.
Builds onHow Antennas and Feedlines Work
Pro12 lessonsAbout 2 hours
Clearing a path around terrain, the loss from the air and the rain, why a signal fades, and choosing a frequency the ionosphere will return.
Builds onHow Radio Waves TravelandHow Antennas and Feedlines Work
We wrote this course to our own syllabus.